104 cm x 5 m Drytac Protac Ultra Gloss UV 75µ
Call: +420 603 587 902
Recommended accessories
Drytac Protac Ultra Gloss is a 50µ polyester carrier coated with a 25µ solvent acrylic adhesive. To maximize the homogeneous mirror effect, it is necessary that the Protac Ultra Gloss UV film is applied to a solid, hard and completely smooth surface. The image will significantly gain depth and color contrast.
This is a polyester laminating film with a "hybrid cross-linked" adhesive and therefore the top quality for cold roller lamination. It does not cause silvering.
Benefits of high-quality laminating films:
- they are extremely light (unlike cover glass)
- dust and moisture cannot get between the self-adhesive laminating film and the image (yes, under the glass)
- increased abrasion resistance and complete water resistance
- high degree of protection against UV radiation and ozone O3 (against image fading)
Lamination tool: roller laminator. Preheating of the film is not necessary.
Recommendations:
- when applying, set high pressure and low feed speed
- laminate fully stabilized (dry) photos; the recommended minimum delay after inkjet printing is 6 hours
- during application the film usually stretches slightly (typically 1 mm per meter of length), so give it time to shrink again and do the final trimming of the laminated photo again at least six hours after lamination
I have a question about the product 104 cm x 5 m Drytac Protac Ultra Gloss UV 75µ
FOMEI Warranty – 6 Months
The media you purchase is stored in a climate-controlled environment, i.e., at the prescribed temperature and relative humidity. This prevents degradation. Therefore, even in the case of extended storage from production to dispatch, you always receive fresh media. Thanks to this, we guarantee flawless media quality with consistent print colors for a full 6 months.
| Handling of Media for Inkjet and Dye-Sub Printers | |
|---|---|
| Storage conditions (original packaging) | 10-20°C, 40-60% RH without condensation |
| Working environment | 15-25°C, 30-70% RH without condensation |
| Optimal printing conditions | 19-23°C, 40-60% RH without condensation |
| Use clean gloves when handling unprinted media. | |